25.000RPM
The capacitive ignition type Direct Ignition TCI 3,5 - 25V
25.000RPM
USB 2.0 Universal Ignition 3,5 - 25V
25.000RPM
RS232 Accessories Sensors
Connectors
Coils
Universal ignition
Download 
Buy Ignition Control application
The electronic ignition consists of many functions and their set-up can be realized through a personal computer with Ignition Control program. The computer communicates through the RS232 interface of speed 19200Bd. That is why the computer must have at least one COM port and/or USB/RS232 transducer. The application works under the Windows 95 or higher. It requires 4MB of empty space in hard disc. The minimum PC configuration is Pentium 166MHz, 32MB RAM is accurate.
Ignition Control Program is divided into four individual parts:
- Online visualisation
- Ignition advance curve
- Extended functions
Online visualisation showing this parameters
- Engine RPM and Advance
- Ignition advance
To run visualization it is always necessary to connect the computer with the ignition by a serial extended cable, to open the communication port and to run the visualization by pressing the button Start. In case that after pressing the button Start the real data do not display please control the connection of communication cable, the number of the used communication port and the voltage of the ignition.
The ignition advance curve
The basic character of the ignition is the directing the ignition advance according to real turns of the engine. To set ignition advance directing characteristics there is Ignition advance curve bookmark.
Flash energy
To optimize the type of the inductors and its excitation there is Flash energy button. It is necessary to set medium or minimum excitation that will protect the inductors against the over excitation and their over heating when using inductors with resistance lower than 4ohm (min 2,5 ohm). If using the inductors with the resistance higher than 4ohm there is medium or maximal excitation settings. The settings of Flash energy directing that directs exciting according to values of board voltage is the compromise of the excitation inductors.
| Board voltage | Control flash energy |
| > 9V | Maximum |
| 9V - 11,5V | Medium |
| < 11,5V / < 3300RPM | Minimum |
| < 11,5V / 3300 - 6500RPM | Medium |
| < 11,5V / > 6500RPM | Maximum |
It possible configuration coil current by exciting curve or table. You can set exciting from 20 to 95% per a round.
Pre-defined process of coil exciting
Acceleration brake
There is a new function in Online visualization. It is Acceleration brake that realizes fast 5 second engine record with the calculation of the turn derivation (acceleration). It proportionately responds to torsional moment.
Measure process
- Check the Engine Turn Limits settings before use
- Leave the engine run idly and get ready for its acceleration
- Press Start button
- Wait exactly 1 second to run the record
- Running of the record for 5 seconds
- End up the record and read the measured values of turns from ignition
- Display and conversion the measured values to the graph
Price 136 EUR
transactions supported